What details should be paid attention to in a Temperature and Humidity Cyclic Test Chamber?

When moving the test chamber, the tilt angle of the box should not exceed 30°, and it should be kept upright during transportation to prevent damage to the equipment.

If the machine is not used for a long time, it should be powered on for at least 1 hour every month.

After each test, remove the test samples and wipe the inner wall of the test chamber to keep the inner box clean.

When the equipment is working, try to reduce the number of times the door is opened to minimize air leakage.

If there is a large fluctuation in the power supply voltage or frequent power outages, the high-low temperature alternating wet and heat test chamber should be suspended, and the power supply should be turned off to prevent damage to the compressor. After the equipment stops, do not immediately reconnect the power supply to start the compressor. Wait for 2-5 minutes before starting.

Cleaning and balancing of the circulating fan blades and condenser fans: Similar to cleaning the evaporator, due to different working environments, many dust particles and small particles may condense on the circulating fan blades and condenser fans. They should be cleaned regularly.

The condenser should be cleaned regularly every three months, and the condenser fan should be checked regularly. Dust and dirt should be removed from the condenser to ensure its good ventilation and heat exchange capacity.

The high-low temperature alternating wet and heat test chamber should be placed in a well-ventilated, low-humidity area with a flat floor. There should be a space of 60-70 cm around it for use.